car wraps near me prices Vinyl wrapping Cutting at tight molding

car wraps near me prices

Sometimes we see vehicles with extremely tight molding around their windows. It can be a challenge to remove the excess vinyl wrapping film from your vehicle. Today we'll be discussing how to remove extra material from tight molding, car wraps near me prices without cutting into the body or molding. We will show you how it is done using Opel Vectra to illustrate. Tight moldings need to be cleaned This is because we have a narrow molding just by the front windshield. It's difficult to remove the excess vinyl film when wrapping vinyl.

First, you need to place it on the edge of your squeegee. You will need to cut the vinyl wrapping material off both sides. You will start by cutting on one side. Next, car wraps near me prices you will go back and place the sharp edge of your squeegee on the other side. Then, you'll need to insert your blade in the opposite side the same way you did the first time. This double-cut is actually a relief cut that you make on one side and then the other. car wraps near me prices The rubber groove is where the tip of your knife will be. You can also take some tension off one side. It is easy to go back and trim the other side, since there is almost no tension. When you take it out, you will be amazed at how small it is. It measures only three millimeters in width. Don't forget to seal it with your squeegee at the end. Although it is difficult to do this, once you have set it up properly and used the sharp edge of the squeegee along with the tip of the knife correctly, it will be easy. Thin rubber under window molding This case study actually uses the same concept as the above. This one is a bit more difficult because there is always think rubber under the window molding, car wraps near me prices and this one is made from chrome. It is difficult to do it right when the vinyl wrap material has to be cut. It is all about preparation. www.vinylcarwrapshop.com car wraps near me prices We won't remove the chrome molding here as it is very easy to trim the edges. We will still get the setup done. There will be a gap where the rubber molding is underneath. Because the chrome side has a sharp edge, we will first cut it. It is technically a relief cut. Your blade should have a shallow tip. It is possible to cut the rubber beneath if we make the blade a bit sharper. Only cut the top of the section first, just in line with the edge of chrome. Then, use the squeegee's hard edge. Because the material is no longer touching the chrome, car wraps near me prices your squeegee will slide right into the groove of rubber. This will give you a clean, sharp edge. Because of the relief cut, there is no need for heating. Now, take your knife, and cut the opposite side. This should be about a 5-degree angle towards rubber. It should also be about 10-degrees from the side. This angle is important because the rubber slides underneath it. Once you have made the cut, you can remove any extra material. You can then seal the wrap by re-sealing the wrap with your squeegee. These cuts are crucial. If we don't make them on the top, and instead force the material in, we will have problems. The edge is now clean and straight, there's no rubber here. It is all about the right setup. Always make the relief cut first to ensure that vinyl wrapping material glides into corners with the help your squeegee. Don't press down too hard on the knife when cutting. Remember that your blade's angle is important. Use a 10-degree angle. If you use your knife at a 20 degree angle, you may damage the vehicle's body. car wraps near me prices If your blade is at a shallow angle (e.g. This will result in you cutting rubber parallel to the section. Make sure you clean the area thoroughly before you start any work. Oil can often get in these areas. car wraps near me prices These areas are very tight and must be cut. If it isn't clean enough or if there is oil in the area, you may have to trim the car. You will be able to remember these things and apply them correctly. Have fun wrapping! Molding Vinyl wrap Wrap tips